Item Description:

Chilicoke's original AP2 (04+) single exhaust cap. The most cost effective, simplest, and completely reversible application to complete your single exhaust modification

All fiberglass parts are made from UV resistant resin and quality glass fiber for the optimal balance between strength and weight, less than one pound!

Installation Guide:

1. Fiberglass parts need to be prepped and painted by professional body/paint shop prior to installation.

2. Thoroughly clean the inside of your exhaust cut out of any rocks, dirt, or road grease.

3. First test fit the cap onto your bumper. Cut included mounting tape into small sections and apply them to the outside edge of the cap as shown. Mounting flange may not fit flushly due to the flexability of urethane bumper, apply multiple layers if necessary.

4. Line up the cap from behind the rear bumper, apply firm pressure on the mounting flange into the surrounding bumper for good tape adhesion.

Disclaimer:

The installation is very simple and straightforward. However, buyer is solely responsible for installation, modification, or any possible damage done to their own vehicle.
I cannot be held responsible for any damage or injuries caused by the buyer, installer, or any other parties involved with the installation.